Of course, this is a maximum. It may, and usually does, take less than this time.
Replacement Mass Air Flow sensor / Airflow Meter / MAF for 1994-1997 Ford Aspire and 1995-1998 Mazda Protege models.
The following are interchangeable (100% compatible) part numbers that this part replaces:
| 213-3346 | 213-3350 | 221001M | 64-1644 | 74-10023 |
| 917-896 | AF10030 | AF10327 | B3H713215 | F4BZ12B579A |
| MA143 | MG0122 |
Applications. The following are the vehicles this unit fits:
- 1994-1997 Ford Aspire Base Hatchback 2-Door 1.3L
- 1995 MAZDA 323 GS 1.5L (Canada Market CDM)
- 1999-2000 Mazda Miata 1.8L
- 1995-1998 Mazda Protege DX/LX 4 Door 1.5L
- 1999-2000 Mazda Protege 1.8L
If the flowmeter of your vehicle is failing, this situation will show different symptoms in different car models, but the symptoms are all related. For example, the most common are:
- Noticeably lower fuel economy
- Black smoke or raw fuel smell from the exhaust
- The engine is not starting or is hard to start
- If the engine starts, very rough idle
- Engine stalling or hesitation
- Uniform soot/carbon dry stain on all spark plugs
- A check-engine code will be shown
The flowmeter is in charge of metering the incoming air to the engine, so the ECM (Engine Control Module) can adjust the amount of fuel being injected, keeping the ideal fuel/air mixture needed.
Are Flowmeters, MAF, and Mass Air Flow Sensors the same?
Yes, it refers to the same part. This is used in car engines to measure the amount of air entering the engine. Earlier designs measured the incoming air by volume, while the newer ones measure the incoming air by mass, which is more accurate for the ECM to calculate fuel injection based on incoming air
IMPORTANT:
- Before investing in this part, always make sure that your vehicle’s engine air filter is clean, as it may also give similar problems if dirty or clogged.
- It is important to clean the throttle and clean or replace the spark plugs after replacing a bad flowmeter to prevent temporary malfunction of the replacement part.
- It is possible that a reset needs to be done in your car with a scanner to erase the old trouble codes and check if any of the codes persist.
- Do not use octane booster products. It is known that those products may cause harm to sensitive electronic fuel injection systems sensors, and parts.
- Do not try to clean the sensor with any harsh chemicals. Only use special cleaning products intended for that purpose.
This is a refurbished product. It has been put back to factory functioning conditions and has been tested and made sure that it works as new. In addition, a reasonable warranty has been included for the peace of mind of our customers.
Some images shown here will be for the only purpose of identifying the product, while in some other cases, the images are the actual product images. That been said, the product you receive may vary slightly from the images shown here. Nevertheless, we always pick the best and cleanest one we have available at the moment of shipping your order :)
TAGS: 1994 1998 ford flowmeter






Read reviews left for us, or leave your own on Trustpilot! Available in the link below:
TechnicalDomain.net Reviews
You may also check our local reviews (left for us on our website):
Reviews
There are no reviews yet.